Power and hand tools, fasteners and hurricane hardware, lumber, concrete, roofing, drywall and safety gear. Prices are in US dollars.
40 products
POW-001
Power Tools
Compact two-speed drill/driver for framing, decking and general fastening, sold as a kit with battery and charger. The 1/2 in keyless chuck takes standard drill and driver bits.
POW-002
Power Tools
Standard corded framing saw for cutting dimensional lumber, plywood and OSB. Bevels to 45 degrees for angled cuts.
POW-003
Power Tools
Small corded grinder for cutting rebar and metal strap, grinding welds and removing rust. Accepts 4-1/2 in cutting, grinding and flap discs.
POW-004
Power Tools
Curve and plunge-cut saw for trim, cabinets and plywood openings. Sold as a kit with one battery and a charger; extra blades are sold separately.
POW-005
Power Tools
Air-powered nailer for wall, floor and roof framing that drives plastic-collated full-round-head nails. Needs an air compressor and hose, sold separately.
HAN-006
Hand Tools & Layout
Everyday claw hammer for driving and pulling nails on framing and carpentry jobs. The steel handle has a rubber grip that cuts down on hand fatigue.
HAN-007
Hand Tools & Layout
Locking steel tape with a wide blade that stays rigid for long standouts. Marked in inches and feet with 1/16 in graduations and stud-layout marks.
HAN-008
Hand Tools & Layout
Rectangular aluminum level for checking walls, framing and forms for plumb, level and 45 degrees. The wide profile resists bending in the toolbox.
HAN-009
Hand Tools & Layout
Pointed trowel for spreading mortar on block and brick courses. The carbon-steel blade and wooden handle suit everyday bricklaying and block work.
HAN-010
Hand Tools & Layout
Light snap-off knife for scoring drywall, cutting roofing felt, tape and packaging. Break off the dull segment for a fresh edge.
FAS-011
Fasteners & Hurricane Hardware
Formed steel clip that connects a roof rafter or truss to the top plate to help resist uplift. Install with the nail size and count shown on the packaging and your plans; in South Florida confirm the connector your inspector requires.
FAS-012
Fasteners & Hurricane Hardware
Heavy-duty wood screws used in place of lag bolts for interior framing connections, beams and ledgers, driven without a pilot hole in softwood. Zinc-plated: for interior/dry use only. For exterior work or treated lumber, use hot-dip galvanized or stainless fasteners. Check the load table before substituting for bolts.
